slm denizci arkadaşlarım.dün trabzon da girmiş olduğum uzakyol vardiya makinistliğinde çıkmıs olan ingilizce sorularını hatırladığım kadarıyla paylaşmak istiyorum.bende bu siteden çalışmıştım.paylaşım yapan arkadaşların soruları sayesinde sınavı ilk denememde geçtim.belki benim paylaşımımdan başka arkadaşlar faydalanılır.bütün arkadaşlarıma sınavlarında başarılar dilerim.
1-Prior to port arrival, a diesel alternator_____________, turbo alternator_____________, and all the full away procedure should be done_____________
a) Will have to be started/will be shut down/in reverse order --
b) Doesnot have to be started/will have to be shut down/in reverse order
c) Will have to be started/will have to be started/in right order
d) Will have to be shut down/will have to be started/in reverse order
e) Doesn’t have to be shut down/will have to be shut down/in right order
2-The instrument always used in conjunction with a salinity indicator is the:
a) Pyrometer
b) Thermometer --
c) Hygrometer
d) Hydrometer
e) Oxygen meter
3-A floating ship displaces water equal to its own weight. What word can be used instead of the underlined word?
a) flooding
b) afloat --
c) rolling
d) pitching
e) mooring
4-The cylinder cover is tightened against liner with studs. What word can be used instead of the underlined word?
a) removed
b) replaced
c) screwed --
d) slackened
e) supported
5-What has not a rotary motion?
a) crankshaft
b) propeller shaft
c) turbine rotor
d) piston --
e) impeller
6-_____________is a process , in which the temperature of a space on whatever takes place in, is reduced below that of their surroundings.
a) Refrigeration --
b) Air conditioning
c) Ventilation
d) Heating
e) Freezing
7-While making your rounds, you notice the main lube oil temperature is higher than normal. To remedy this situation, you should:
a) Speed up the main lube oil pump
b) Open the lube oil cooler seawater inlet valve wider
c) Throttle in on the lube oil cooler seawater discharge valve
d) Close the lube oil cooler seawater discharge valve wider
e) Open the lube oil cooler seawater discharge valve wider. --
8-Sprinklers shall be placed in an overhead position to maintain an average application rate of not less than 5 l/m²/min over the area covered by the sprinklers.
What word can be used instead of the underlined word?
a) run
b) keep --
c) place
d) repair
e) change
9-The purpose of transformers is to_____________the voltage.
a) increase
b) raise
c) complete
d) reduce --
e) insulate
10-It is prohibited by law that the discharge of untreated sewage in restricted waters. What word can be used instead of the underlined word?
a) insufficient
b) raw
c) refined
d) separated
e) contaminated
11-Studs and nuts intended for use in main steam line flanges and fittings are marked with an “H†or a “T†to show they are:
a) Heat resistant --
b) Hard finished
c) Half threaded
d) Corrosion resistant
e) Fire proof
12-When distilling salt water the cooling-water discharge from the distiller is fed back to the evaporator as feedwater:
a) To cut down on the amount of cooling water needed
b) To prevent an excess amount of cooling water from being discharged to the bilges
c) To supply hot water to the evaporator for more economical operation --
d) To supply sufficient amount of sea water
e) None of the above
13-_____________protects the pump shafts from erosion, corrosion and wear
a) Wearing rings
b) Renewable sleeves --
c) A hardened metal coating
d) Internally flooded lantern rings
e) Lantern rings
14-cevabı ballasting olan bır soru vardı.deniz suyu ile balast alma işleminin karsılığı kelımeyi sormustu.
10.sorunun cvbını net bılmedıgım ıcın ısaretlemedım
1-Prior to port arrival, a diesel alternator_____________, turbo alternator_____________, and all the full away procedure should be done_____________
a) Will have to be started/will be shut down/in reverse order --
b) Doesnot have to be started/will have to be shut down/in reverse order
c) Will have to be started/will have to be started/in right order
d) Will have to be shut down/will have to be started/in reverse order
e) Doesn’t have to be shut down/will have to be shut down/in right order
2-The instrument always used in conjunction with a salinity indicator is the:
a) Pyrometer
b) Thermometer --
c) Hygrometer
d) Hydrometer
e) Oxygen meter
3-A floating ship displaces water equal to its own weight. What word can be used instead of the underlined word?
a) flooding
b) afloat --
c) rolling
d) pitching
e) mooring
4-The cylinder cover is tightened against liner with studs. What word can be used instead of the underlined word?
a) removed
b) replaced
c) screwed --
d) slackened
e) supported
5-What has not a rotary motion?
a) crankshaft
b) propeller shaft
c) turbine rotor
d) piston --
e) impeller
6-_____________is a process , in which the temperature of a space on whatever takes place in, is reduced below that of their surroundings.
a) Refrigeration --
b) Air conditioning
c) Ventilation
d) Heating
e) Freezing
7-While making your rounds, you notice the main lube oil temperature is higher than normal. To remedy this situation, you should:
a) Speed up the main lube oil pump
b) Open the lube oil cooler seawater inlet valve wider
c) Throttle in on the lube oil cooler seawater discharge valve
d) Close the lube oil cooler seawater discharge valve wider
e) Open the lube oil cooler seawater discharge valve wider. --
8-Sprinklers shall be placed in an overhead position to maintain an average application rate of not less than 5 l/m²/min over the area covered by the sprinklers.
What word can be used instead of the underlined word?
a) run
b) keep --
c) place
d) repair
e) change
9-The purpose of transformers is to_____________the voltage.
a) increase
b) raise
c) complete
d) reduce --
e) insulate
10-It is prohibited by law that the discharge of untreated sewage in restricted waters. What word can be used instead of the underlined word?
a) insufficient
b) raw
c) refined
d) separated
e) contaminated
11-Studs and nuts intended for use in main steam line flanges and fittings are marked with an “H†or a “T†to show they are:
a) Heat resistant --
b) Hard finished
c) Half threaded
d) Corrosion resistant
e) Fire proof
12-When distilling salt water the cooling-water discharge from the distiller is fed back to the evaporator as feedwater:
a) To cut down on the amount of cooling water needed
b) To prevent an excess amount of cooling water from being discharged to the bilges
c) To supply hot water to the evaporator for more economical operation --
d) To supply sufficient amount of sea water
e) None of the above
13-_____________protects the pump shafts from erosion, corrosion and wear
a) Wearing rings
b) Renewable sleeves --
c) A hardened metal coating
d) Internally flooded lantern rings
e) Lantern rings
14-cevabı ballasting olan bır soru vardı.deniz suyu ile balast alma işleminin karsılığı kelımeyi sormustu.
10.sorunun cvbını net bılmedıgım ıcın ısaretlemedım